When testing, use the ohm gear of the multimeter (depending on the nominal resistance value to determine the gear, generally R1 gear), which can be operated in two steps: first, test at normal temperature (indoor temperature is close to 25 degree ), use alligator clips instead of test pens to clip them separately. Measure the actual resistance value of the two pins of the PTC thermistor, and compare it with the nominal resistance value. If the difference between the two is within ±2Ω, it is normal. If the actual resistance value is too different from the nominal resistance value, it means that its performance is poor or damaged. Secondly, heating test, on the basis of normal temperature test, the second step test - heating test can be carried out, a heat source (such as an electric soldering iron) is heated close to the thermistor, and the multi-function indicator is observed. It is seen that the multi-function indicator changes with the increase of temperature, which indicates that the resistance value is gradually changing (the NTC resistance value of the negative temperature coefficient thermistor will become smaller, and the PTC resistance value of the positive temperature coefficient thermistor will become larger) , When the resistance value changes to a certain value, the displayed data will gradually stabilize, indicating that the thermistor is normal. If the resistance value does not change, it indicates that its performance has deteriorated and cannot be used continuously.
Taka skal fram eftirfarandi atriði meðan á prófun stendur: (1) Rt er mælt af framleiðanda þegar umhverfishiti er 25 gráður, þannig að þegar Rt er mæld með margmæli ætti það einnig að framkvæma þegar umhverfishiti er nálægt 25 gráðum til tryggja prófunarhæfni. áreiðanleika. (2) Mælikrafturinn skal ekki fara yfir tilgreint gildi til að forðast mæliskekkjur sem stafa af hitauppstreymi straumsins. (3) Gefðu gaum að réttri notkun. Þegar þú prófar skaltu ekki klípa hitastigshólfið með höndum þínum til að koma í veg fyrir að líkamshiti manns hafi áhrif á prófið. (4) Gættu þess að gera hitagjafann og PTC hitastillinn ekki of nálægt eða hafa beint samband við hitastillinn til að koma í veg fyrir að hann brennist.
